Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual page 1703

Table 232: VLAN Configuration Details (continued)
Field Function
Ports Specifies the ports (interfaces) to be
associated with this VLAN for data
traffic. You can also remove the port
association.
IP address tab
IPv4 address Specifies IPv4 address options for the
VLAN.
IPv6 address Specifies IPv6 address options for the
VLAN.
Voip tab
Ports Specifies the ports to be associated
with this VLAN for voice traffic. You can
also remove the port association.
Related
Documentation
Copyright © 2010, Juniper Networks, Inc.
Configuring VLANs for EX Series Switches (CLI Procedure) on page 1600
Example: Setting Up Basic Bridging and a VLAN for an EX Series Switch on page 1525
Understanding Bridging and VLANs on EX Series Switches on page 1501
Configuring Routed VLAN Interfaces (CLI Procedure) on page 1601
Chapter 65: Configuring Bridging and VLANs
Your Action
Click one:
—Select the ports from the available list.
Add
—Select the port that you do not want
Remove
associated with the VLAN.
Select s to enable the IPv4 address options.
IPv4 addres
To configure IPv4:
1. Enter the IP address.
2. Enter the subnet mask—for example,
You can also specify the address prefix.
3. To apply an input firewall filter to an interface, select
the firewall filter from the list.
4. To apply an output firewall filter to an interface, select
the firewall filter from the list.
5. Click the ARP/MAC Details
address and MAC address in the window that is
displayed.
Select s to enable the IPv6 address options.
IPv6 addres
To configure IPv6:
1. Enter the IP address—for example:
2001:ab8:85a3::8a2e:370:7334
2. Specify the subnet mask.
Click one:
Add —Select the ports from the available list.
—Select the port that you do not want
Remove
associated with the VLAN.
.
255.255.255.0
button. Enter the static IP
.
1599