Chapter 82 Examples: Igmp Snooping And Multicast Configuration; Example: Configuring Igmp Snooping On Ex Series Switches - Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual

CHAPTER 82
Examples: IGMP Snooping and Multicast
Configuration

Example: Configuring IGMP Snooping on EX Series Switches

Requirements
Copyright © 2010, Juniper Networks, Inc.
Example: Configuring IGMP Snooping on EX Series Switches on page 2543
Example: Configuring Multicast VLAN Registration on EX Series Switches on page 2546
IGMP snooping regulates multicast traffic in a switched network. With IGMP snooping
enabled, a LAN switch monitors the IGMP transmissions between a host (a network
device) and a multicast router, keeping track of the multicast groups and associated
member ports. The switch uses that information to make intelligent multicast-forwarding
decisions and forward traffic to the intended destination interfaces.
Configure IGMP snooping on one or more VLANs to allow the switch to examine IGMP
packets and make forwarding decisions based on packet content. By default, IGMP
snooping is enabled on EX Series switches.
This example describes how to configure IGMP snooping:
Requirements on page 2543
Overview and Topology on page 2544
Configuration on page 2544
This example uses the following software and hardware components:
One EX3200-24T switch
Junos OS Release 9.5 or later for EX Series switches
Before you configure IGMP snooping, be sure you have:
Configured the
employee-vlan
Assigned interfaces ge-0/0/1
See "Example: Setting Up Bridging with Multiple VLANs for EX Series Switches" on
page 1532.
VLAN on the switch
, ge-0/0/2 , and ge-0/0/3 to employee-vlan
2543