Table 259: Spanning-Tree Protocol Configuration Parameters - Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual

Table 259: Spanning-Tree Protocol Configuration Parameters

Field Function
General
Protocol Name Specifies the spanning-tree protocol type: STP, MSTP, or
RSTP.
Disable Disables spanning-tree protocol on the interface.
BPDU Protect Specifies BPDU protection on all edge interfaces on the
switch.
Bridge Priority Specifies the bridge priority. The bridge priority determines
which bridge is elected as the root bridge. If two bridges
have the same path cost to the root bridge, the bridge
priority determines which bridge becomes the designated
bridge for a LAN segment.
Forward Delay Specifies the number of seconds an interface waits before
changing from spanning-tree learning and listening states
to the forwarding state.
Hello Time Specifies the time interval in seconds at which the root
bridge transmits configuration BPDUs.
Copyright © 2010, Juniper Networks, Inc.
NOTE: After you make changes to the configuration in this page, you must
commit the changes for them to take effect. To commit all changes to
the active configuration, select
Commit Options to Commit Configuration Changes for details about all
commit options.
Click one:
2.
Add —Creates a spanning-tree protocol configuration.
Select a protocol name.
a.
Enter information as described in Table 259 on page 1815.
b.
Click OK to apply changes to the configuration or click
c.
saving changes.
—Modifies a selected spanning-tree protocol configuration.
Edit
Enter information as described in Table 259 on page 1815.
a.
Click to apply changes to the configuration or click
b. OK
saving changes.
Delete —Deletes a selected spanning-tree protocol configuration.
Chapter 72: Configuring Spanning-Tree Protocols
>
Commit Options Commit
Cancel to cancel without
to cancel without
Cancel
Your Action
None.
To enable this option, select the check box.
To enable this option, select the check box.
Select a value from the list.
Type a value.
Type a value.
. See Using the
1815