Show Isis Backup Coverage; Table 302: Show Isis Backup Coverage Output Fields - Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual

show isis backup coverage

Syntax
Syntax (EX Series
Switch)
Release Information
Description
Options
Required Privilege
Level
Related
Documentation
List of Sample Output
Output Fields
Copyright © 2010, Juniper Networks, Inc.
show isis backup coverage
<instance instance-name>
<logical-system (all | logical-system-name)>
show isis backup coverage
<instance instance-name>
Command introduced in Junos OS Release 9.5.
Command introduced in Junos OS Release 9.5 for EX Series switches.
Display information about the level of backup coverage available.
—Display information about the level of backup coverage available for all the nodes
none
and prefixes in the network.
instance instance-name —(Optional) Display information about the level of backup coverage
for a specific IS-IS routing instance.
logical-system (all | logical-system-name)
systems or on a particular logical system.
view
show isis backup label-switched-path on page 2331
show isis backup coverage on page 2330
Table 302 on page 2329 lists the output fields for the
Output fields are listed in the approximate order in which they appear.

Table 302: show isis backup coverage Output Fields

Field Name Field Description
Topology Type of topology or address family:
IS-IS level:
Level
By topology, the percentage of all routes configured on the node that
Node
are protected through backup coverage.
Percentage of IPv4 unicast routes that are protected through backup
IPv4 Unicast
coverage.
Percentage of IPv6 unicast routes that are protected through backup
IPv6 Unicast
coverage.
Chapter 80: Operational Commands for Layer 3 Protocols
—(Optional) Perform this operation on all logical
show isis backup coverage
1 —Level 1
2 —Level 2
command.
IPV4 Unicast or IPV6 Unicast .
2329