Table 325: State Output Field Values - Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual

Complete Software Guide for Junos
2426
®
OS for EX Series Ethernet Switches, Release 10.4
Table 325 on page 2426 describes all possible values for the
be in more than one state (for example,

Table 325: State Output Field Values

Value
Accounting
Active
Always Compare MED
AS path
Clone
Cisco Non-deterministic MED
selection
Cluster list length
Delete
Ex
Ext
FlashAll
Hidden
IfCheck
IGP metric
Local Preference
Inactive reason
Initial
Int
Int Ext
<Active NoReadvrt Int Ext>
Description
Route needs accounting.
Route is active.
Path with a lower multiple exit discriminator (MED) is
available.
Shorter AS path is available.
Route is a clone.
Cisco nondeterministic MED is enabled and a path with a lower
MED is available.
Length of cluster list sent by the route reflector.
Route has been deleted.
Exterior route.
BGP route received from an external BGP neighbor.
Forces all protocols to be notified of a change to any route,
active or inactive, for a prefix. When not set, protocols are
informed of a prefix only when the active route changes.
Route not used because of routing policy.
Route needs forwarding RPF check.
Path through next hop with lower IGP metric is available.
Path with a higher local preference value is available.
Flags for this route, which was not selected as best for a
particular destination.
Route being added.
Interior route.
BGP route received from an internal BGP peer or a BGP
confederation peer.
Copyright © 2010, Juniper Networks, Inc.
output field. A route can
State
).