Table 281: Summary Of Key Ospf Routing Output Fields - Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual

Complete Software Guide for Junos

Table 281: Summary of Key OSPF Routing Output Fields

Field
OSPF Interfaces
Interface
State
Area
DR ID
BDR ID
Neighbors
Adjacency Count
Stub Type
Passive Mode
Authentication Type
Interface Address
Address Mask
MTU
Interface Cost
Hello Interval
Dead Interval
Retransmit Interval
1936
®
OS for EX Series Ethernet Switches, Release 10.4
Values
Name of the interface running OSPF.
State of the interface: ,
BDR Down
, , or .
Loop PtToPt Waiting
Number of the area that the interface is in.
Address of the area's designated device.
Address of the area's backup designated device.
Number of neighbors on this interface.
Number of devices in the area using the same
area identifier.
The areas into which OSPF does not flood AS
external advertisements
In this mode the interface is present on the
network but does not transmit or receive
packets.
The authentication scheme for the backbone or
area.
The IP address of the interface.
The subnet mask or address prefix.
The maximum transmission unit size.
The path cost used to calculate the root path
cost from any given LAN segment is determined
by the total cost of each link in the path.
How often the routing device sends hello
packets out of the interface.
The interval during which the routing device
receives no hello packets from the neighbor.
The interval for which the routing device waits
to receive a link-state acknowledgment packet
before retransmitting link-state advertisements
to an interface's neighbors.
Additional Information
, , , The state, indicating that the interface is
DR DRother Down
not functioning, and
a point-to-point connection has been
established, are the most common states.
Copyright © 2010, Juniper Networks, Inc.
state, indicating that
PtToPt