Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual page 1868

Complete Software Guide for Junos
Configuring RSTP on Switch 1
CLI Quick
Configuration
Step-by-Step
Procedure
1764
®
OS for EX Series Ethernet Switches, Release 10.4
To configure RSTP on Switch 1, perform these tasks:
To quickly configure interfaces and RSTP on Switch 1, copy the following commands and
paste them into the switch terminal window:
[edit]
set vlans voice-vlan description "Voice VLAN"
set vlans voice-vlan vlan-id 10
set vlans employee-vlan description "Employee VLAN"
set vlans employee-vlan vlan-id 20
set vlans guest-vlan description "Guest VLAN"
set vlans guest-vlan vlan-id 30
set vlans camera-vlan description "Camera VLAN"
set vlans camera-vlan vlan-id 40
set interfaces ge-0/0/13 unit 0 family ethernet-switching vlan members [10 20 30 40]
set interfaces ge–0/0/9 unit 0 family ethernet-switching vlan members [10 20 30 40]
set interfaces ge–0/0/11 unit 0 family ethernet-switching vlan members [10 20 30 40]
set interfaces ge–0/0/13 unit 0 family ethernet-switching port-mode trunk
set interfaces ge-0/0/9 unit 0 family ethernet-switching port-mode trunk
set interfaces ge-0/0/11 unit 0 family ethernet-switching port-mode trunk
set protocols rstp bridge-priority 16k
set protocols rstp interface ge-0/0/13.0 cost 1000
set protocols rstp interface ge-0/0/13.0 mode point-to-point
set protocols rstp interface ge-0/0/9.0 cost 1000
set protocols rstp interface ge-0/0/9.0 mode point-to-point
set protocols rstp interface ge-0/0/11.0 cost 1000
set protocols rstp interface ge-0/0/11.0 mode point-to-point
To configure interfaces and RSTP on Switch 1:
Configure the VLANs
1.
[edit vlans]
user@switch1# set voice-vlan description "Voice VLAN"
user@switch1# set voice-vlan vlan-id 10
user@switch1# set employee-vlan description "Employee VLAN"
user@switch1# set employee-vlan vlan-id 20
user@switch1# set guest-vlan description "Guest VLAN"
user@switch1# set guest-vlan vlan-id 30
user@switch1# set camera-vlan description "Camera VLAN"
user@switch1# set guest-vlan vlan-id 40
Configure the VLANs on the interfaces, including support for the Ethernet Switching
2.
protocol:
[edit interfaces]
user@switch1# set ge-0/0/13 unit 0 family ethernet-switching vlan members [10 20
30 40]
user@switch1# set ge-0/0/9 unit 0 family ethernet-switching vlan members [10 20 30
40]
user@switch1# set ge-0/0/11 unit 0 family ethernet-switching vlan members [10 20
30 40]
Configure the port mode for the interfaces:
3.
[edit interfaces]
user@switch1# set ge-0/0/13 unit 0 family ethernet-switching port-mode trunk
user@switch1# set ge-0/0/9 unit 0 family ethernet-switching port-mode trunk
, ,
voice-vlan employee-vlan
, and
guest-vlan camera-vlan
Copyright © 2010, Juniper Networks, Inc.
: