Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual page 2092

Complete Software Guide for Junos
Options
1988
®
OS for EX Series Ethernet Switches, Release 10.4
authentication algorithm algorithm-name
the specified BFD session:
meticulous-keyed-md5
authentication key-chain key-chain-name
BFD session using the name of the security keychain. The name you specify must
match one of the keychains configured in the
statement at the
[edit security]
authentication loose-check
BFD session. Use only for transitional periods when authentication may not be
configured at both ends of the BFD session.
detection-time threshold milliseconds
Forwarding Detection (BFD) protocol session detection time adapts to a value equal
to or greater than the threshold, a single trap and a single system log message are
sent.
holddown-interval milliseconds
must remain up before a state change notification is sent.
Range: 0 through 255,000
Default: 0
local-address ip-address —Enable a multihop BFD session and configure the source address
for the BFD session.
minimum-interval milliseconds
routing device transmits a hello packet and then expects to receive a reply from the
neighbor with which it has established a BFD session.
Range: 1 through 255,000
minimum-receive-interval milliseconds
local routing device expects to receive a reply from a neighbor with which it has
established a BFD session.
Range: 1 through 255,000
minimum-receive-ttl number
session.
Range: 1 through 255
Default: 255
—Configure number of hello packets not received by the neighbor that
multiplier number
causes the originating interface to be declared down.
Range: 1 through 255
Default: 3
neighbor address —Configure a next-hop address for the BFD session for a next hop
specified as an interface name.
—Configure the algorithm used to authenticate
,
simple-password keyed-md5
, or meticulous-keyed-sha-1
—Associate a security key with the specified
authentication-key-chains key-chain
hierarchy level.
—(Optional) Configure loose authentication checking on the
—Configure a threshold. When the Bidirectional
—Configure an interval specifying how long a BFD session
—Configure the minimum intervals at which the local
—Configure the minimum interval at which the
—Configure the time-to-live (TTL) for the multihop BFD
, ,
keyed-sha-1
.
Copyright © 2010, Juniper Networks, Inc.