Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual page 1684

Complete Software Guide for Junos
Meaning
Related
Documentation
Example: Configuring Automatic VLAN Administration Using MVRP on EX Series
Switches
Requirements
Overview and Topology
1580
®
OS for EX Series Ethernet Switches, Release 10.4
r2.inet.0
Each routing instance created is displayed, along with its type, information about whether
it is active or not, and its primary routing table.
Configuring Virtual Routing Instances (CLI Procedure) on page 1606
As a network expands and the number of clients and VLANs increases, VLAN
administration becomes complex and the task of efficiently configuring VLANs on multiple
EX Series switches becomes increasingly difficult. To automate VLAN administration,
you can enable Multiple VLAN Registration Protocol (MVRP) on the network.
MVRP can also be used to dynamically create VLANs, further simplifying the network
overhead required to statically configure VLANs.
NOTE: Only trunk interfaces can be enabled for MVRP.
This example describes how to use MVRP to automate administration of VLAN
membership changes within your network and how to use MVRP to dynamically create
VLANs:
Requirements on page 1580
Overview and Topology on page 1580
Configuring VLANs and MVRP on Access Switch A on page 1583
Configuring VLANs and MVRP on Access Switch B on page 1585
Configuring VLANS and MVRP on Distribution Switch C on page 1587
Verification on page 1588
This example uses the following hardware and software components:
Two EX Series access switches
One EX Series distribution switch
Junos OS Release 10.0 or later for EX Series switches
MVRP is used to manage dynamic VLAN registration in a LAN. It can also be used to
dynamically create VLANs.
1/0/0
Copyright © 2010, Juniper Networks, Inc.