Verifying That Mac Notification Is Working Properly; Verifying That Proxy Arp Is Working Correctly - Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual

Related
Documentation

Verifying That MAC Notification Is Working Properly

Purpose
Action
Meaning
Related
Documentation

Verifying That Proxy ARP Is Working Correctly

Purpose
Action
Copyright © 2010, Juniper Networks, Inc.
The output for
show mvrp statistics interface xe-0/1/1.0
are being transmitted and received on the interface.
Example: Configuring Automatic VLAN Administration Using MVRP on EX Series
Switches on page 1580
Configuring Multiple VLAN Registration Protocol (MVRP) (CLI Procedure) on page 1611
Verify that MAC notification is enabled or disabled, and that the MAC notification interval
is set to the specified value.
Verify that MAC notification is enabled while also verifying the MAC notification interval
setting.
user@switch> show ethernet-switching mac-notification
Notification Status: Enabled
Notification Interval: 30
The output in the
Notification Status
output in the Notification Status
disabled.
The field output shows that the MAC notification interval is set to
Notification Interval
30 seconds.
Configuring MAC Notification (CLI Procedure) on page 1616
Verify that the switch is sending proxy ARP messages.
List the system statistics for ARP:
user@switch> show system statistics arp
arp:
198319 datagrams received
45 ARP requests received
12 ARP replies received
2 resolution requests received
2 unrestricted proxy requests
0 restricted proxy requests
0 received proxy requests
0 proxy requests not proxied
0 restricted-proxy requests not proxied
0 with bogus interface
0 with incorrect length
0 for non-IP protocol
0 with unsupported op code
0 with bad protocol address length
0 with bad hardware address length
0 with multicast source address
Chapter 66: Verifying Bridging and VLAN Configuration
confirms that MVRP messages
field shows that MAC notification is enabled. The
field would display Disabled if MAC notification was
1631