Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual page 2089

Required Privilege
Level
Related
Documentation
Copyright © 2010, Juniper Networks, Inc.
authentication loose-check
BFD session. Use only for transitional periods when authentication may not be
configured at both ends of the BFD session.
detection-time threshold milliseconds
detection time adapts to a value equal to or greater than the threshold, a single trap
and a single system log message are sent.
minimum-interval milliseconds
routing device transmits a hello packet and then expects to receive a reply from the
neighbor with which it has established a BFD session.
Range: 1 through 255,000 milliseconds
minimum-receive-interval milliseconds
the local routing device expects to receive a reply from a neighbor with which it has
established a BFD session.
Range: 1 through 255,000 milliseconds
multiplier number —Configure the number of hello packets not received by a neighbor
that causes the originating interface to be declared down.
Range: 1 through 255
Default: 3
—Configure BFD sessions not to adapt to changing network conditions.
no-adaptation
We recommend that you not disable BFD adaptation unless it is preferable not to
have BFD adaptation enabled in your network.
transmit-interval threshold milliseconds
transmit interval adapts to a value greater than the threshold, a single trap and a
single system log message are sent. The interval threshold must be greater than the
minimum transmit interval.
Range: 0 through 4,294,967,295 (2
transmit-interval minimum-interval milliseconds
which the local routing device transmits hello packets to a neighbor.
Range: 1 through 255,000
version —Specify the BFD version to detect.
Range: (BFD version 1), or
Default:
automatic
The remaining statements are explained separately.
routing—To view this statement in the configuration.
routing-control—To add this statement to the configuration.
Configuring BFD for RIP
Configuring BFD Authentication for RIP
Chapter 79: Configuration Statements for Layer 3 Protocols
—(Optional) Configure loose authentication checking on the
—Configure a threshold. When the BFD session
—Configure the minimum intervals at which the local
—Configure only the minimum interval at which
—Configure a threshold. When the BFD session
32
– 1)
—Configure only a minimum interval at
(autodetect the version)
automatic
1985