Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual page 1921

Table 259: Spanning-Tree Protocol Configuration Parameters (continued)
Field Function
Interface Mode Specifies the link mode.
BPDU Timeout Specifies the BPDU timeout action for the interface.
Action
MSTI
(MSTP only)
MSTI Name Specifies a name (an MSTI ID) for the MST instance.
Bridge Priority Specifies the bridge priority. The bridge priority determines
which bridge is elected as the root bridge. If two bridges
have the same path cost to the root bridge, the bridge
priority determines which bridge becomes the designated
bridge for a LAN segment.
VLAN ID Specifies the VLAN for the MST instance.
Copyright © 2010, Juniper Networks, Inc.
Chapter 72: Configuring Spanning-Tree Protocols
Your Action
1. To enable the option, select the check box.
2. Select one:
–For a full-duplex link, the
Point to Point
default link mode is point-to-point.
–For a half-duplex link, the
Shared
default link mode is shared.
Select one:
Alarm
Block
1. Click the tab.
MSTI
2. Choose one:
Click .
Add
Select an MSTI ID and click
To delete an MSTI from the
configuration, select the MSTI ID and
slick Remove .
Select a value from the list.
In the VLAN box, choose one:
Click Add , select a VLAN from the list and
click OK .
To remove a VLAN association, select the
VLAN ID, click Remove , and click
Edit .
OK .
1817