Table 232: Vlan Configuration Details - Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual

Complete Software Guide for Junos

Table 232: VLAN Configuration Details

Field Function
General tab
VLAN Name Specifies a unique name for the VLAN.
VLAN Id/Range Specifies the identifier or range for the
VLAN.
Description Describes the VLAN.
MAC-Table-Aging-Time Specifies the maximum time that an
entry can remain in the forwarding
table before it 'ages out'.
Input filter Specifies the VLAN firewall filter that
is applied to incoming packets.
Output filter Specifies the VLAN firewall filter that
is applied to outgoing packets.
Ports tab
1598
®
OS for EX Series Ethernet Switches, Release 10.4
NOTE: After you make changes to the configuration in this page, you must
commit the changes immediately for them to take effect. To commit all
changes to the active configuration, select Commit Options > Commit.
See Using the Commit Options to Commit Configuration Changes for
details about all commit options.
Click one:
2.
—creates a VLAN.
Add
—edits an existing VLAN configuration.
Edit
—deletes an existing VLAN.
Delete
NOTE: If you delete a VLAN, the VLAN configuration for all the
associated interfaces is also deleted.
When you are adding or editing a VLAN, enter information as described in Table 232
on page 1598.
Your Action
Enter a name.
Select one:
VLAN ID—Type a unique identification number from
through . If no value is specified, it defaults to 1.
4094
VLAN Range—Type a number range to create VLANs
with IDs corresponding to the range. For example, the
range will create two VLANs with the IDs
2–3
Enter a brief description for the VLAN.
Type the number of seconds from
To apply an input firewall filter, select the firewall filter
from the list.
To apply an output firewall filter, select the firewall filter
from the list.
Copyright © 2010, Juniper Networks, Inc.
1
and .
2 3
through .
60 1000000