Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual page 2080

Complete Software Guide for Junos
Options
1976
®
OS for EX Series Ethernet Switches, Release 10.4
authentication algorithm algorithm-name
the specified BFD session:
meticulous-keyed-md5
authentication key-chain key-chain-name
BFD session using the name of the security keychain. The keychain name must match
one of the keychains configured in the
at the hierarchy level.
[edit security]
authentication loose-check
BFD session. Use only for transitional periods when authentication may not be
configured at both ends of the BFD session.
detection-time threshold milliseconds
detection time adapts to a value equal to or greater than the threshold, a single trap
and a single system log message are sent.
holddown-interval milliseconds
must remain up before a state change notification is sent.
Range: 0 through 255,000
Default: 0
NOTE: You can configure the
minimum-interval milliseconds
routing device transmits hello packets and then expects to receive a reply from a
neighbor with which it has established a BFD session.
Range: 1 through 255,000
minimum-receive-interval milliseconds
the local routing device expects to receive a reply from a neighbor with which it has
established a BFD session.
Range: 1 through 255,000
—Configure the number of hello packets not received by a neighbor
multiplier number
that causes the originating interface to be declared down.
Range: 1 through 255
Default: 3
—Configure BFD sessions not to adapt to changing network conditions.
no-adaptation
We recommend that you not disable BFD adaptation unless it is preferable to not
to have BFD adaptation enabled in your network.
transmit-interval threshold milliseconds
transmit interval adapts to a value greater than the threshold, a single trap and a
single system message are sent. The interval threshold must be greater than the
minimum transmit interval.
Range: 0 through 4,294,967,295 (2
—Configure the algorithm used to authenticate
,
simple-password keyed-md5
, meticulous-keyed-sha-1 .
—Associate a security key with the specified
authentication-key-chains key-chain
—(Optional) Configure loose authentication checking on the
—Configure a threshold. When the BFD session
—Configure an interval specifying how long a BFD session
holddown-interval
—Configure the minimum intervals at which the local
— Configure only the minimum interval at which
—Configure a threshold. When the BFD session
32
– 1)
, ,
keyed-sha-1
statement
option only for EBGP peers.
Copyright © 2010, Juniper Networks, Inc.