Configuration
CLI Quick
Configuration
Copyright © 2010, Juniper Networks, Inc.
Figure 53: MVR Topology in Proxy Mode
For information on VLAN tagging, see "Understanding Bridging and VLANs on EX Series
Switches" on page 1501.
To configure MVR perform these tasks:
To quickly configure MVR in proxy mode, copy the following commands and paste them
into the switch terminal window. To quickly configure MVR in transparent mode (the
default mode), do not copy and paste the final command line in the following block of
lines:
[edit protocols igmp-snooping]
set vlan mv0 data-forwarding source groups 225.10.0.0/16
set vlan v2 data-forwarding receiver source-vlans mv0
set vlan v2 data-forwarding receiver install
set vlan mv0 proxy source-address 10.1.1.1
Chapter 82: Examples: IGMP Snooping and Multicast Configuration
2549