Configuring Multiple Vlan Registration Protocol (Mvrp) (Cli Procedure); Enabling Mvrp; Table 234: Rtg Configuration Fields - Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual

Table 234: RTG Configuration Fields

Field
Group Name
Member Interface 1
Member Interface 2
Select Primary Interface
Dynamically select my active
interface
Related
Documentation

Configuring Multiple VLAN Registration Protocol (MVRP) (CLI Procedure)

Enabling MVRP

Copyright © 2010, Juniper Networks, Inc.
Function
Specifies a unique name for the RTG.
Specifies a logical interface containing multiple trunk
interfaces.
Specifies a trunk interface containing multiple VLANs.
Enables you to specify one of the interfaces in the RTG
as the primary link. The interface without this option is
the secondary link in the RTG.
Specifies that the system dynamically selects the
active interface.
Example: Configuring Redundant Trunk Links for Faster Recovery on page 1563
Understanding Redundant Trunk Links on EX Series Switches on page 1512
Multiple VLAN Registration Protocol (MVRP) is used to manage dynamic VLAN registration
in a LAN. You can use MVRP on EX Series switches.
MVRP is disabled by default on EX Series switches.
To enable MVRP or set MVRP options, follow these instructions:
Enabling MVRP on page 1611
Disabling MVRP on page 1612
Disabling Dynamic VLANs on page 1612
Configuring Timer Values on page 1612
Configuring MVRP Registration Mode on page 1613
MVRP can only be enabled on trunk interfaces.
To enable MVRP on all trunk interfaces on the switch:
[edit protocols mvrp]
user@switch# set interface all
To enable MVRP on a specific trunk interface:
[edit protocols mvrp]
user@switch# set interface xe-0/0/1.0
Chapter 65: Configuring Bridging and VLANs
Your Action
Enter a name.
Select a trunk interface from the list.
Select a trunk interface from the list.
1. Select the option button.
2. Select the primary interface.
Select the option button.
1611