Table 305: Show Isis Database Output Fields - Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual

Table 305: show isis database Output Fields

Field Name Field Description
Name of the interface on which the LSP has been received; always
Interface name
command.
Level of intermediate system:
level
—Intermediate system routes within an area; when the destination is outside
1
an area, it routes toward a Level 2 system.
—Intermediate system routes between areas and toward other ASs.
2
LSP ID Link-state PDU identifier.
Sequence Sequence number of the link-state PDU.
Checksum Checksum value of the link-state PDU.
Remaining lifetime of the link-state PDU, in seconds.
Lifetime (secs)
Attributes of the specified database:
Attributes
# Total number of LSPs in the specified link-state database.
LSPs
Prefix advertised by this link-state PDU.
IP prefix
IS-IS neighbor of the advertising system.
IS neighbor
(J Series routers only) An ES-IS neighbor of the advertising system.
ES neighbor
IPv4 prefix advertised by this link-state PDU.
IP prefix
IPv6 prefix advertised by this link-state PDU.
V6 prefix
Metric of the prefix or neighbor.
Metric
Header LSP ID
Length
Allocated Length
Router ID
Remaining Lifetime
Copyright © 2010, Juniper Networks, Inc.
L1
—Link state PDU identifier of the header.
—Header length.
—Amount of length available for the header.
—Address of the local routing device.
—Remaining lifetime of the link-state PDU, in seconds.
Chapter 80: Operational Commands for Layer 3 Protocols
IS-IS
, , , or (L1 only).
L2 Overload Attached
Level of Output
for this All levels
All levels
All levels
All levels
All levels
All levels
none
brief
none
brief
detail extensive
detail extensive
detail extensive
detail extensive
detail extensive
detail extensive
extensive
2337