Creating A Series Of Tagged Vlans (Cli Procedure); Configuring Bridging And Vlans - Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual

CHAPTER 65

Configuring Bridging and VLANs

Configuring VLANs for EX Series Switches (J-Web Procedure)
Copyright © 2010, Juniper Networks, Inc.
Configuring VLANs for EX Series Switches (J-Web Procedure) on page 1597
Configuring VLANs for EX Series Switches (CLI Procedure) on page 1600
Configuring Routed VLAN Interfaces (CLI Procedure) on page 1601
Configuring MAC Table Aging (CLI Procedure) on page 1602
Configuring the Native VLAN Identifier (CLI Procedure) on page 1603
Creating a Series of Tagged VLANs (CLI Procedure) on page 1604
Configuring Virtual Routing Instances (CLI Procedure) on page 1606
Creating a Private VLAN on a Single EX Series Switch (CLI Procedure) on page 1607
Configuring Q-in-Q Tunneling (CLI Procedure) on page 1608
Configuring GVRP (J-Web Procedure) on page 1608
Configuring Redundant Trunk Groups (J-Web Procedure) on page 1610
Configuring Multiple VLAN Registration Protocol (MVRP) (CLI Procedure) on page 1611
Configuring Layer 2 Protocol Tunneling on EX Series Switches (CLI
Procedure) on page 1614
Configuring MAC Notification (CLI Procedure) on page 1616
Configuring Proxy ARP (CLI Procedure) on page 1617
You can use the VLAN Configuration page to add a new VLAN or to edit or delete an
existing VLAN on an EX Series switch.
To access the VLAN Configuration page:
Select >
1. Configure Switching
The VLAN Configuration page displays a list of existing VLANs. If you select a specific
VLAN, the specific VLAN details are displayed in the Details section.
> .
VLAN
1597