Table 288: Show (Ospf | Ospf3) Neighbor Output Fields - Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual

Complete Software Guide for Junos
Related
Documentation
List of Sample Output
Output Fields

Table 288: show (ospf | ospf3) neighbor Output Fields

Field Name Field Description
Address Address of the neighbor.
Interface Interface through which the neighbor is reachable.
State State of the neighbor:
Attempt
indicates that no recent information has been received from the neighbor,
but that a more concerted effort must be made to contact the neighbor.
Down
information has been received from the neighbor. Hello packets might
continue to be sent to neighbors in the
frequency.
Exchange
sending database description packets to the neighbor. Each packet has a
sequence number and is explicitly acknowledged.
ExStart
routing devices. The goal of this step is to determine which routing device is
the master, and to determine the initial sequence number.
Full
in router link and network link advertisements.
Init —A Hello packet has recently been sent by the neighbor. However,
bidirectional communication has not yet been established with the neighbor.
This state may occur, for example, because the routing device itself did not
appear in the neighbor's hello packet.
Loading
recent advertisements that have been discovered (but not yet received) in
the
2Way
state has been ensured by the operation of the Hello Protocol. This is the
most advanced state short of beginning adjacency establishment. The
(backup) designated router is selected from the set of neighbors in state
2Way
Router ID of the neighbor.
ID
2274
®
OS for EX Series Ethernet Switches, Release 10.4
clear (ospf | ospf3) neighbor on page 2242
show ospf neighbor brief on page 2275
show ospf neighbor detail on page 2275
show ospf neighbor extensive on page 2276
show ospf3 neighbor detail on page 2277
show ospf neighbor area area-id on page 2277
show ospf neighbor interface interface-name on page 2277
show ospf3 neighbor instance all (OSPFv3 Multiple Family Address Support
Enabled) on page 2277
Table 288 on page 2274 lists the output fields for the
Output fields are listed in the approximate order in which they appear.
—Valid only for neighbors attached to nonbroadcast networks. It
—Initial state of a neighbor conversation. It indicates that no recent
—Routing device is describing its entire link-state database by
—First step in creating an adjacency between the two neighboring
—Neighboring routing devices are fully adjacent. These adjacencies appear
—Link-state request packets are sent to the neighbor to acquire more
state.
Exchange
—Communication between the two routing devices is bidirectional. This
or greater.
show (ospf | ospf3) neighbor
Down state, although at a reduced
Copyright © 2010, Juniper Networks, Inc.
command.
Level of Output
All levels
All levels
All levels
All levels