Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual page 1692

Complete Software Guide for Junos
Step-by-Step
Procedure
Results
Verification
1588
®
OS for EX Series Ethernet Switches, Release 10.4
To configure distribution Switch C for MVRP:
Configure the trunk interface to access Switch A:
1.
[edit]
user@Distribution-Switch-C# set interfaces xe-0/1/1 unit 0 family ethernet-switching
port-mode trunk
Configure the trunk interface to access Switch B:
2.
[edit]
user@Distribution-Switch-C# set interfaces xe-0/1/0 unit 0 family ethernet-switching
port-mode trunk
Enable MVRP on the trunk interface for
3.
[edit]
user@Distribution-Switch-C# set protocols mvrp interface xe-0/1/1.0
Enable MVRP on the trunk interface for
4.
[edit]
user@Distribution-Switch-C# set protocols mvrp interface xe-0/1/0.0
Check the results of the configuration:
[edit]
user@Distribution Switch-D# show
interfaces {
xe-0/1/0 {
unit 0 {
family ethernet-switching {
port-mode trunk;
}
}
}
xe-0/1/1 {
unit 0 {
family ethernet-switching {
port-mode trunk;
}
}
}
}
protocols {
mvrp {
interface xe-0/1/0.0;
interface xe-0/1/1.0;
}
To confirm that the configuration is updating VLAN membership, perform these tasks:
Verifying That MVRP Is Enabled on Access Switch A on page 1589
Verifying That MVRP Is Updating VLAN Membership on Access Switch A on page 1589
Verifying That MVRP Is Enabled on Access Switch B on page 1589
xe-0/1/1 :
:
xe-0/1/0
Copyright © 2010, Juniper Networks, Inc.