Switches; Figure 44: Network Topology For Rstp - Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual

Complete Software Guide for Junos
Requirements
Overview and Topology
1762
®
OS for EX Series Ethernet Switches, Release 10.4
This example uses the following hardware and software components:
Junos OS Release 9.0 or later for EX Series switches
Four EX Series switches
Before you configure the switches for RSTP, be sure you have:
Installed the four switches. See installation instructions for your switch.
Performed the initial software configuration on all switches. See "Connecting and
Configuring an EX Series Switch (J-Web Procedure)" on page 201.
In this example, four EX Series switches are connected in the topology displayed in Figure
44 on page 1762 to create a loop-free topology.

Figure 44: Network Topology for RSTP

The interfaces shown in Table 253 on page 1763 will be configured for RSTP.
NOTE: You can configure RSTP on logical or physical interfaces. This example
shows RSTP configured on logical interfaces.
Copyright © 2010, Juniper Networks, Inc.