Table 273: Ospf Routing Configuration Summary - Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual

For ex series ethernet switches
Table of Contents

Advertisement

Complete Software Guide for Junos

Table 273: OSPF Routing Configuration Summary

Field
Function
General tab
Area Id
Uniquely identifies the
area within its AS.
Area Ranges
Specifies a range of IP
addresses for an area
when sending summary
link advertisements
(within an area).
1914
®
OS for EX Series Ethernet Switches, Release 10.4
Select
>
1.
Configure
Routing
NOTE: After you make changes to the configuration in this page, you must
commit the changes for them to take effect. To commit all changes to
the active configuration, select
Commit Options to Commit Configuration Changes for details about all
commit options.
Click one:
2.
—Adds an OSPF area. Enter information into the configuration page as described
Add
in Table 273 on page 1914.
Edit
—Modifies an existing OSPF area. Enter information into the configuration page
as described in Table 273 on page 1914.
—Deletes an existing OSPF area.
Delete
To modify OSPF global settings, click
3.
274 on page 1916.
To disable OSPF, click Disable.
4.
Your Action
Type a 32-bit numeric identifier for the area. Type an integer or select and edit
the value.
If you enter an integer, the value is converted to a 32-bit equivalent. For example,
if you enter 3, the value assigned to the area is
To add a range:
1.
Click
Add
2. Type the area range.
3. Specify the subnet mask.
4. To override the metric for the IP address range, type a specific metric value.
5. If you do not want to display the routes that are contained within a summary,
select
Restrict advertisements of this area range
6. If you want a summary of a route to be advertised only when an exact match
is made with the configured summary range, select
advertisement of this area range
7. Click
OK
To modify an existing area range, select the area range, click
value. Click
To delete an area range, select the area range and click
>
.
OSPF
Commit Options
. Enter information as described in Table
Edit
.
.
.
.
OK
>
Commit
. See Using the
.
0.0.0.3
.
Enforce exact match for
, and edit the
Edit
.
Delete
Copyright © 2010, Juniper Networks, Inc.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Junos os 10.4

Table of Contents