Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual page 1687

Table 231: Components of the Network Topology (continued)
Interfaces
Configuring VLANs and MVRP on Access Switch A
CLI Quick
Configuration
Copyright © 2010, Juniper Networks, Inc.
To configure VLANs on the switch, bind access interfaces to the VLANs, and enable MVRP
on the trunk interface of access Switch A, perform these tasks:
To quickly configure access Switch A for MVRP, copy the following commands and paste
them into the switch terminal window of Switch A:
[edit]
set vlans finance vlan-id 100
set vlans lab vlan-id 200
set vlans sales vlan-id 300
set interfaces ge-0/0/1 unit 0 family ethernet-switching vlan members finance
set interfaces ge-0/0/2 unit 0 family ethernet-switching vlan members lab
set interfaces ge-0/0/3 unit 0 family ethernet-switching vlan members sales
set interfaces xe-0/1/1 unit 0 family ethernet-switching port-mode trunk
set protocols mvrp interface xe-0/1/1.0
NOTE: As we recommend as a best practice, default MVRP timers are used
in this example. The default values associated with each MVRP timer are:
200 ms for the join timer, 1000 ms for the leave timer, and 10000 ms for the
leaveall timer. Modifying timers to inappropriate values might cause an
imbalance in the operation of MVRP.
Chapter 64: Examples: Bridging and VLAN Configuration
Access Switch A interfaces:
ge-0/0/1 —Connects PC1 to access Switch A.
ge-0/0/2 —Connects PC2 to access Switch A.
—Connects PC3 to access Switch A.
ge-0/0/3
—Connects access Switch A to distribution Switch
xe-0/1/1
C (trunk).
Access Switch B interfaces:
—Connects PC4 to access Switch B.
ge-0/0/0
—Connects PC5 to access Switch B.
ge-0/0/1
—Connects access Switch B to distribution Switch
xe-0/1/0
C. (trunk)
Distribution Switch C interfaces:
—Connects distribution Switch C to access Switch
xe-0/1/1
A. (trunk)
—Connects distribution Switch C to access Switch
xe-0/1/0
B. (trunk)
1583