Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual page 1599

Table 221: show lacp interfaces Output Fields (continued)
Field Name Field Description
LACP state information for each aggregated Ethernet interface:
LACP State
Copyright © 2010, Juniper Networks, Inc.
For a child interface configured with force-up, LACP state displays FUP along with the interface
name.
—Role played by the interface. It can be one of the following:
Role
—Local device participating in LACP negotiation.
Actor
—Remote device participating in LACP negotiation.
Partner
—Expired state. indicates the actor or partner is in an expired state.
Exp Yes
or partner is not in an expired state.
Def —Default. Yes indicates that the actor's receive machine is using the default operational partner
information, administratively configured for the partner.
information in use has been received in an LACP PDU.
Dist —Distribution of outgoing frames.
currently disabled and is not expected to be enabled. Otherwise, the value is
—Collection of incoming frames.
Col
currently enabled and is not expected to be disabled. Otherwise, the value is
—Synchronization. If the value is
Syn
to the correct link aggregation group, the group has been associated with a compatible aggregator,
and the identity of the link aggregation group is consistent with the system ID and operational key
information transmitted. If the value is
aggregation.
—Ability of aggregation port to aggregate (
Aggr
—LACP timeout preference. Periodic transmissions of LACP PDUs occur at either a slow
Timeout
or fast transmission rate, depending upon the expressed LACP timeout preference (
or Short Timeout ).
—Actor or partner's port activity.
Activity
LAC PDUs unless its partner's control value is
participate in the protocol regardless of the partner's control value.
Chapter 62: Operational Commands for Interfaces
No indicates the operational partner
No indicates distribution of outgoing frames on the link is
indicates collection of incoming frames on the link is
Yes
, the link is considered synchronized. It has been allocated
Yes
, the link is not synchronized. It is currently not in the right
No
) or to operate only as an individual link (
Yes
indicates the port's preference for not transmitting
Passive
. indicates the port's preference to
Active Active
indicates the actor
No
.
Yes
.
No
).
No
Long Timeout
1495