Chapter 64 Examples: Bridging And Vlan Configuration; Example: Setting Up Basic Bridging And A Vlan For An Ex Series Switch - Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual

CHAPTER 64
Examples: Bridging and VLAN
Configuration

Example: Setting Up Basic Bridging and a VLAN for an EX Series Switch

Requirements
Copyright © 2010, Juniper Networks, Inc.
Example: Setting Up Basic Bridging and a VLAN for an EX Series Switch on page 1525
Example: Setting Up Bridging with Multiple VLANs for EX Series Switches on page 1532
Example: Connecting an Access Switch to a Distribution Switch on page 1540
Example: Configure Automatic VLAN Administration Using GVRP on page 1549
Example: Configuring Redundant Trunk Links for Faster Recovery on page 1563
Example: Setting Up Q-in-Q Tunneling on EX Series Switches on page 1568
Example: Configuring a Private VLAN on a Single EX Series Switch on page 1571
Example: Using Virtual Routing Instances to Route Among VLANs on EX Series
Switches on page 1577
Example: Configuring Automatic VLAN Administration Using MVRP on EX Series
Switches on page 1580
Example: Configuring Layer 2 Protocol Tunneling on EX Series Switches on page 1592
EX Series switches use bridging and virtual LANs (VLANs) to connect network devices
in a LAN—desktop computers, IP telephones, printers, file servers, wireless access points,
and others—and to segment the LAN into smaller bridging domains. The switch's default
configuration provides a quick setup of bridging and a single VLAN.
This example describes how to configure basic bridging and VLANs for an EX Series
switch:
Requirements on page 1525
Overview and Topology on page 1526
Configuration on page 1527
Verification on page 1531
This example uses the following software and hardware components:
1525