Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual page 1591

Table 219: show interfaces xe- Output Fields (continued)
Field Name Field Description
Number and rate of bytes and packets received (input) and transmitted (output)
Traffic statistics
on the specified interface.
Number and rate of bytes and packets destined to and from the switch.
Local statistics
Number and rate of bytes and packets transiting the switch.
Transit statistics
Protocol family.
Protocol
Unique number for use by Juniper Networks technical support only.
Generation
Route table in which the logical interface address is located. For example,
Route Table
refers to the routing table
Names of any input filters applied to this interface.
Input Filters
Names of any output filters applied to this interface.
Output Filters
Information about protocol family flags.
Flags
If unicast reverse-path forwarding (RPF) is explicitly configured on the specified
interface, the uRPF flag is displayed. If unicast RPF was configured on a different
interface (and therefore is enabled on all switch interfaces) but was not explicitly
configured on the specified interface, the uRPF flag is not displayed even though
unicast RPF is enabled.
Addresses, Flags Information about the address flags.
Protocol family configured on the logical interface. If the protocol is
protocol-family
address of the interface is also displayed.
Information about the address flags.
Flags
IP address of the remote side of the connection.
Destination
IP address of the logical interface.
Local
Copyright © 2010, Juniper Networks, Inc.
.
inet.0
Chapter 62: Operational Commands for Interfaces
Level of Output
detail
extensive
extensive
extensive
detail
extensive
none
detail
extensive
0 detail
extensive
none
detail
extensive
detail
extensive
detail
extensive
detail
extensive
none
, the IP
inet brief
detail
extensive
none
detail
extensive
none
detail
extensive
none
1487