Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual page 1564

Complete Software Guide for Junos
Table 216: show interfaces ge- Output Fields (continued)
Field Name Field Description
Information about link autonegotiation:
Autonegotiation
information
Negotiation status:
Incomplete
No autonegotiation
configured or does not perform autonegotiation.
Complete
autonegotiation and the autonegotiation process is successful.
Link partner status
performs autonegotiation and the autonegotiation process is successful.
Link partner:
Link mode
either
Flow control
device. For Gigabit Ethernet interfaces, types are
supports
PAUSE
PAUSE
Remote fault
indicates a receive link error.
Negotiation error
link partner is going offline.
Link partner speed
Local resolution
Flow control
device. For Gigabit Ethernet interfaces, types are
supports
PAUSE
PAUSE
Remote fault
receive),
detected on receive).
Packet Forwarding Information about the configuration of the Packet Forwarding Engine:
Engine
Destination slot
configuration
NOTE: On an EX2200, EX3200, or EX4500 switch or an EX4200 standalone
switch, the FPC slot number refers to the switch itself and is always
EX4200 Virtual Chassis, the FPC slot number refers to the member ID. On an
EX8200 standalone switch, the FPC slot number refers to the line card slot
number on the switch. On an EX8200 Virtual Chassis, the FPC slot number
refers to the line card slot number on the Virtual Chassis.
Logical Interface
Logical interface Name of the logical interface.
Index Index number of the logical interface, which reflects its initialization sequence.
SNMP ifIndex SNMP interface index number for the logical interface.
1460
®
OS for EX Series Ethernet Switches, Release 10.4
—Ethernet interface has the speed or link mode configured.
—Remote Ethernet interface has the speed or link mode
—Ethernet interface is connected to a device that performs
— OK when Ethernet interface is connected to a device that
—Depending on the capability of the attached Ethernet device,
or .
Full-duplex Half-duplex
—Types of flow control supported by the remote Ethernet
on receive and transmit),
PAUSE
on transmit), and
Symmetric/Asymmetric
on both receive and transmit or
—Remote fault information from the link partner—
indicates that the link partner is receiving.
OK
indicates a negotiation error.
—Speed of the link partner.
—Information from the link partner:
—Types of flow control supported by the remote Ethernet
on receive and transmit),
PAUSE
on transmit), and Symmetric/Asymmetric
on both receive and transmit or
—Remote fault information.
Offline (local interface is offline), and
—FPC slot number.
(link partner
Symmetric
(link partner supports
Asymmetric
(link partner supports
only on receive).
PAUSE
Failure
Offline indicates that the
(link partner
Symmetric
(link partner supports
Asymmetric
(link partner supports
PAUSE only on receive).
Link OK (no error detected on
Link Failure (link error
. On an
0
Copyright © 2010, Juniper Networks, Inc.
Level of Output
extensive
extensive
All levels
detail extensive none
detail extensive none