Table of Contents
Advertisement
CHAPTER 5
Configuring Ethernet Interfaces
Ethernet Overview
Copyright © 2010, Juniper Networks, Inc.
This chapter describes how to configure Ethernet interfaces on E Series Broadband
Services Routers.
Most of the procedures described here do not apply to the Fast Ethernet management
port on the SRP module. You can, however, select and display statistics for that port by
using commands described in this chapter. For information about managing the Fast
Ethernet port on the SRP module, see JunosE System Basics Configuration Guide.
This chapter contains the following sections:
Ethernet Overview on page 167
Ethernet Interface Platform Considerations on page 168
Fast Ethernet I/O Modules on page 170
Gigabit Ethernet I/O Modules and IOAs on page 171
10-Gigabit Ethernet IOAs on page 182
Ethernet References on page 186
High-Density Ethernet on page 187
Managing Port Redundancy on Gigabit Ethernet I/O Modules on page 188
Configuration Tasks for Ethernet on page 189
Configuring the Physical Interface on page 190
Disabling Ethernet Interfaces on page 195
Monitoring Ethernet Interfaces on page 196
Ethernet modules support the following Ethernet interfaces:
Fast Ethernet
Gigabit Ethernet
10-Gigabit Ethernet
This section describes features that are available with Ethernet interfaces.
167
Advertisement
Table of Contents
