Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual page 235

Table 23: Statements for Logical Interface Properties (continued)
Statement
service-domain (inside | outside)
shaping
short-sequence
source source-address
swap
swap-push
swap-swap
tag-protocol-id tpid
transmit-weight number
(traps | no-traps)
trunk-bandwidth rate
trunk-id number
ttl number
tunnel
underlying-interface
vbr peak rate sustained rate burst
length
vci vpi-identifiervci-identifier
Interface Types
Adaptive services interfaces
ATM1 and ATM2 IQ interfaces
Multilink interfaces
Encryption, GRE tunnel, and IP tunnel
interfaces
Gigabit Ethernet IQ interfaces
Gigabit Ethernet IQ interfaces
Gigabit Ethernet IQ interfaces
Gigabit Ethernet and Gigabit Ethernet IQ
and IQE PICs with SFPs (except the
10-port Gigabit Ethernet PIC, Aggregated
Ethernet with Gigabit Ethernet IQ
interfaces, and the built-in Gigabit Ethernet
port on the M7i router)
ATM2 IQ interfaces
All
ATM2 IQ interfaces
ATM2 IQ interfaces
GRE tunnel and IP tunnel interfaces
Encryption, GRE tunnel, and IP tunnel
interfaces
IP demux interfaces
ATM interfaces
ATM1 and ATM2 IQ point-to-point
interfaces
Chapter 4: Configuring Logical Interface Properties
Usage Guidelines
JUNOS Services Interfaces Configuration
Guide
"Defining the ATM Traffic-Shaping Profile"
on page 326
JUNOS Services Interfaces Configuration
Guide
JUNOS Services Interfaces Configuration
Guide
"Configuring Frames with Particular TPIDs
to Be Processed as Tagged Frames" on
page 668
"Rewriting a VLAN Tag and Adding a New
Tag" on page 679
"Rewriting the Inner and Outer VLAN
Tags" on page 679
"Rewriting the VLAN Tag on Tagged
Frames" on page 675
"Configuring the ATM2 IQ Transmission
Weight" on page 336
"Enabling or Disabling SNMP Notifications
on Logical Interfaces" on page 171
"Configuring Layer 2 Circuit Trunk Mode
Scheduling" on page 317
"Configuring Layer 2 Circuit Transport
Mode" on page 308
JUNOS Services Interfaces Configuration
Guide
JUNOS Services Interfaces Configuration
Guide
"Specifying the Demux Underlying
Interface" on page 259
"Defining the ATM Traffic-Shaping Profile"
on page 326
"Configuring a Point-to-Point ATM1 or
ATM2 IQ Connection" on page 324
Logical Interfaces Statements List
165