Installing Driveline - MacDon FlexDraper FD1 Series Operator's Manual

5.6.2 Installing Driveline

DANGER
To avoid bodily injury or death from unexpected start-up of machine, always stop engine and remove key
from ignition before leaving operator's seat for any reason.
IMPORTANT:
If the combine output shaft splines match the float module input shaft splines, ensure the driveline is installed with
the longer guard at the float module gearbox end.
IMPORTANT:
Ensure the driveline length corresponds with the length specifications for your specific equipment. Refer to
Specifications, page 21.
1. Position combine end of driveline (A) onto storage
support (B). Pull back the collar (C) on the driveline and
slide driveline onto support until it locks in place.
Release collar (C).
2. For drivelines equipped with safety chains, attach
chain (D) at combine end to driveline storage
support (B).
3. Slide the shield (A) over the driveline (B).
4. Position driveline quick disconnect onto float module
gearbox shaft, pull back collar, and slide onto shaft until
it locks in place. Release the collar.
5. Position the shield (A) on the gearbox and secure with
bolts (C).
6. For drivelines equipped with safety chains, attach
chain (D) at module end to chain (E) on shield.
214683
MAINTENANCE AND SERVICING
Figure 5.35: Combine End of Driveline
Figure 5.36: Float Module End of Driveline
413
A
C
A
E
2.2
C
B
D
B
D
Revision A