Converting From Wide Configuration To Medium Configuration - MacDon FlexDraper FD1 Series Operator's Manual

4.1.2 Converting from Wide Configuration to Medium Configuration

46
One kit of MD #287031
Wide and Medium auger configurations are shown at right.
When converting from Wide configuration to Medium
configuration, you will need to install new flightings (A).
1. If necessary to improve access and ease installation, remove float module from combine. For instructions, refer
to 4 Header Attachment/Detachment, page
NOTE:
Auger illustrated without header for clarity.
2. Remove bolts (A) and remove the access cover (B) on
the right side of the auger. Retain for later reassembly.
NOTE:
If necessary, remove multiple access covers for ease of
access.
3. Remove and discard the two flighting slot plugs (C) on
the right side of the auger.
46. MD #287031 contains wear-resistant flightings, and is available only through MacDon Parts.
214683
HEADER ATTACHMENT/DETACHMENT
is required to convert to this configuration.
307.
1
2
A
Figure 4.11: Auger Configurations (Rear View)
1 - Wide Configuration
C
Figure 4.12: Wide Configuration (Right Side)
313
A
2 - Medium Configuration
A
B
Revision A