Reel Endshields; Replacing Reel Endshields - MacDon FlexDraper FD1 Series Operator's Manual

Combine header

Hide thumbs Also See for FlexDraper FD1 Series:

Table of Contents

28. Reattach the channels (C) to the two left-facing

supports (A) on each reel with screws (B) and nuts.

Torque screws to 43 Nm (32 lbf∙ft).

29. Using screws (E), reinstall any fingers (D) that were

previously removed. Refer to

5.15.6 Reel Endshields

Reel endshields and supports do not require regular maintenance, but they should be checked periodically for

damage and loose or missing fasteners. Slightly dented or deformed endshields and supports are repairable, but

it's necessary to replace severely damaged components.

You can attach reel endshields to either end of the reel.

To avoid bodily injury or death from unexpected start-up of machine, always stop engine and remove key

from ignition before leaving operator's seat for any reason.

1. Lower the header and reel.

2. Shut down the engine, and remove the key from the

3. Rotate the reel manually until the reel endshield (A)

requiring replacement is accessible.

4. Remove three bolts (B).

MAINTENANCE AND SERVICING

Installing Plastic Fingers,

Figure 5.267: Opposite Support

Figure 5.268: Reel Endshields