MacDon FlexDraper FD1 Series Operator's Manual page 410

Knifeheads; refer to
S
390
50 Hours or Annually
Driveline and driveline universals; refer to
S
Every 50 Hours, page 391
Upper cross auger center support and
S
U-joint; refer to Every 50 Hours, page 391
Center draper roller bearings, 3 locations;
S
refer to Every 50 Hours, page 391
Knife drive box lubricant (first 50 hours
▲
only); refer to Changing Oil in Knife Drive
Box, page 461
Header drive gearbox lubricant (first 50
▲
hours only); refer to
Header Drive Gearbox, page 405
100 Hours or Annually (Whichever Occurs First)
Auger to pan and feed draper clearance;
ü
refer to 5.7.1 Adjusting Auger to Pan
Clearance, page 419
Draper seal; refer to
ü
Height, page 492
Gearbox lubricant level; refer to
ü
Oil Level in Header Drive Gearbox, page
404
Reel drive chain tension; refer to
ü
Reel Drive Chain Tension, page 528
Reel finger/cutterbar clearance; refer to
ü
Adjusting Reel Clearance, page 505
Knife drive belt tension; refer to
ü
Drive Belts, page 462
Wheel bolt torque; refer to
ü
Wheel Bolt Torque, page 542
Knife drive box lubricant level; refer to
ü
Checking Knife Drive Box, page 454
Knife drive box mounting bolts; refer to
ü
Checking Mounting Bolts, page 455
Auger drive chain; refer to
S
Hours, page 393
Float pivots; refer to
S
page 393
Float module auger pivots; refer to
S
100 Hours, page 393
214683
MAINTENANCE AND SERVICING
Every 25 Hours, page
Changing Oil in
5.14.5 Adjusting Deck
Checking
5.16.2
5.9.2 Knife
5.17.1 Checking
Every 100
Every 100 Hours,
Every
NOTE: MacDon recommends keeping a record of daily
maintenance as evidence of a properly maintained
machine; however, daily maintenance records are not
required to meet normal warranty conditions.
386
Revision A