Installing Feed Draper Drive Roller
1. Apply grease to the spline.
2. Slide drive roller cover plate (A) onto right end of
roller (B).
3. Guide bearing end (C) of drive roller through frame
opening (D).
4. Slide left end of drive roller (A) onto spline of motor (B).
5. Secure the bearing and housing (A) with the drive roller
cover plate on the frame using two bolts (B).
6. Install the feed deck draper. Refer to
Feed Draper, page
466.
7. Tension the feed draper. Refer to
Draper Tension, page
214683
MAINTENANCE AND SERVICING
5.10.1 Replacing
5.10.2 Adjusting Feed
468.
A
Figure 5.154: Drive Roller (Bearing End)
Figure 5.155: Motor
Figure 5.156: Drive Roller Bearing
472
C
B
A
B
B
A
Revision A
D
1013317