MacDon FlexDraper FD1 Series Operator's Manual page 511

6. Attach the ends of the draper with tube connectors (B),
screws (A) (with the heads facing the center opening),
and nuts.
7. Adjust the draper tension. Refer to
Draper Tension, page
8. Check clearance (A) between drapers (B) and
cutterbar (C). Clearance should be 0–3 mm (0–1/8 in.).
Refer to 5.14.5 Adjusting Deck Height, page 492
adjust if necessary.
9. If adjustment of the backsheet deflector (A) is required,
loosen nut (D) and move the deflector until there is a
1–7 mm (1/32–5/16 in.) gap (C) between the draper (B)
and the deflector.
10. Operate the drapers with the engine at idle so the talc
or talc/graphite lubricant makes contact and adheres to
the draper seal surfaces.
214683
MAINTENANCE AND SERVICING
5.14.3 Adjusting
488.
A
Figure 5.185: Draper Connector
C
to
Figure 5.186: Draper Seal
B
Figure 5.187: Draper Seal
487
B
B
A
A
D
C
Revision A