9. Raise the handle (A) to release the multicoupler (B)
from the float module.
10. Push the handle (A) on the combine to the fully-open
position.
11. Clean the mating surfaces of the multicoupler (B) and
receptacle if necessary.
12. Position the multicoupler (A) onto the combine
receptacle, and pull the handle (B) to fully engage the
multicoupler into the receptacle.
13. Connect the reel fore-aft/header tilt selector harness (C)
to the combine harness (D).
214683
HEADER ATTACHMENT/DETACHMENT
343
B
Figure 4.73: Float Module Multicoupler
B
Figure 4.74: Combine Receptacle
D
C
Figure 4.75: Multicoupler
A
1016869
A
B
A
Revision A