MacDon FlexDraper FD1 Series Operator's Manual page 560

4. Support the inboard end of the right reel with a front end
loader and nylon slings (A) (or equivalent lifting device).
IMPORTANT:
Avoid damaging or denting the center tube by
supporting the reel as close to the end disc as possible.
5. Remove the four bolts (A) securing the reel tube to the
U-joint flange (B).
6. Move the right reel sideways to separate the reel
tube (A) from the U-joint (B).
7. Remove the drive chain (C).
8. Route the new chain (C) over the U-joint (B) and
position onto the sprockets.
214683
MAINTENANCE AND SERVICING
Figure 5.296: Supporting Reel
Figure 5.297: U-Joint
Figure 5.298: Replacing Chain
536
A
B
C
A
A
B
Revision A