NOTE:
The feeder house fore/aft tilt controls can be changed to
work with buttons E and F by pressing the control handle
icon (A) and then selecting FEEDER HOUSE FORE/AFT
TILT from the drop-down menu (B).
To calibrate the feeder house fore-aft tilt range, follow these steps:
1. Ensure center-link is set to D.
2. Rest header on down stops and unlock float.
3. Place wings in locked position.
4. Press the DIAGNOSTIC icon (A) on the main screen of
the monitor. The CALIBRATION screen displays.
214683
OPERATION
Figure 3.367: John Deere Combine Display
Figure 3.368: John Deere Combine Display
223
A
B
A
Revision A