5.7.4 Removing Auger Drive Chain
The chain tensioner can take up slack for only a single pitch. Replace the chain when the chain has worn or
stretched beyond the limits of the tensioner.
DANGER
To avoid bodily injury or death from unexpected start-up of machine, always stop engine and remove key
from ignition before leaving operator's seat for any reason.
NOTE:
Replace chain with endless chain (MD #220317).
1. Tilt header fully back to maximize space between auger and feed pan.
2. Detach header from combine. Refer to
3. On the left side of the auger, remove the four bolts (A)
and inspection panel (B).
4. Remove bolts (C) and remove indicator/clamp (D) that
holds the two covers (G) and (H) together.
5. Remove bolt and washer (J) that secure that
bottom cover.
6. Remove the two bolts (E) and remove cover
retainer (F).
7. Rotate top (G) and bottom (H) cover forward to remove.
214683
MAINTENANCE AND SERVICING
4 Header Attachment/Detachment, page
Figure 5.55: Auger Drive (Left Side)
424
307.
B
F
G
C
D
C
A
E
J
H
Revision A