3. Insert pin (A) into the aft setting holes, and through the
cylinder end (C) and washers (D). Secure the pin with
ring (B).
Reposition left reel arm cylinder as follows:
NOTE:
Some reel components are not shown in illustrations for improved clarity.
NOTE:
Reels on European-configured headers are at their most forward setting when cylinders are set in position 2 on the
support brackets. Reels on these headers are in their most aft position when cylinders are set in position 1 on the
support brackets.
1. Remove ring (A) and pin (B) inside the left fore-aft
support bracket (D) securing the cylinder (C). Retain pin
and ring.
214683
OPERATION
Figure 3.119: Right Reel Arm Cylinder in Aft
Position
D
Figure 3.120: Left Reel Arm Cylinder in Forward
Position
107
A
B
C
C
D
B
A
Revision A