Replacing Feed Draper Idler Roller Bearing - MacDon FlexDraper FD1 Series Operator's Manual

4. Close the feed draper and secure with connector
straps (B), screws (A), and nuts.
5. Tension the feed draper. Refer to
Draper Tension, page

Replacing Feed Draper Idler Roller Bearing

1. Remove the dust cap (A).
2. Remove nut (A).
3. Use a hammer to tap the bearing assembly (B) until it
slides off the shaft.
214683
MAINTENANCE AND SERVICING
5.10.2 Adjusting Feed
468.
A
Figure 5.168: Draper Connector
Figure 5.169: Idler Roller
B
Figure 5.170: Idler Roller
477
B
A
A
Revision A