Operating Header (Gleaner S9 Series) - MacDon FlexDraper FD1 Series Operator's Manual

NOTE:
Touch the CALIBRATION icon (A) on the COMBINE
MAIN MENU screen to open the CALIBRATION MENU
where you can choose from a variety of calibrations
including header and reel calibration.

Operating Header (Gleaner S9 Series)

NOTE:
Changes may have been made to the combine controls or display since this document was published. Refer to the
combine operator's manual for updates.
The following controls are used to operate the auto header
height control (AHHC) functions:
•
Tyton Terminal (A)
•
Control Handle (B)
•
Throttle (C)
•
Header Control Cluster (D)
Use the combine operator's manual to familiarize yourself
with the controls.
1. With the header running, set lateral tilt switch (A) to
MANUAL.
2. Engage the AHHC by pressing the switch (B) upward to
the I position.
214683
OPERATION
Figure 3.305: Direct Calibration Menu
A
B
C
Figure 3.306: Gleaner S9
B
Figure 3.307: Header Control Cluster
195
A
D
A
Revision A