Converting From Ultra Narrow Configuration Or Narrow Configuration To Medium Configuration - MacDon FlexDraper FD1 Series Operator's Manual

To convert to Ultra Narrow configuration from Medium or Wide configuration, refer to
Medium Configuration or Wide Configuration to Ultra Narrow Configuration, page
To convert to Ultra Narrow configuration from Narrow configuration, refer to
Configuration to Ultra Narrow Configuration, page
4.1.1 Converting from Ultra Narrow Configuration or Narrow Configuration
to Medium Configuration
Two kits of MD #287031
Ultra Narrow, Narrow, and Medium auger configurations are
shown at right. When converting from Ultra Narrow
configuration or Narrow configuration to Medium
configuration, you will need to replace the existing
flightings (A) with flightings (B).
1. To improve access and ease installation, remove float module from combine. For instructions, refer to
Attachment/Detachment, page
NOTE:
Some parts have been removed from the illustrations for clarity.
45. MD #287031 contains wear-resistant flightings, and is available only through MacDon Parts.
214683
HEADER ATTACHMENT/DETACHMENT
45 are required to convert to this configuration.
307.
327.
1
A
2
3
Figure 4.5: Auger Configurations (Rear View)
1 - Narrow Configuration
3 - Medium Configuration
310
4.1.8 Converting from
323.
4.1.9 Converting from Narrow
A
A
A
B
B
2 - Ultra Narrow Configuration
4 Header
Revision A