Adjusting Header Raise Rate (New Holland Cr/Cx Series); Setting The Header Lower Rate (New Holland Cr/Cx Series) - MacDon FlexDraper FD1 Series Operator's Manual

Adjusting Header Raise Rate (New Holland CR/CX Series)

If necessary, the header raise rate (the first speed on the HEADER HEIGHT rocker switch of the multifunctional
handle) can be adjusted.
NOTE:
Changes may have been made to the combine controls or display since this document was published. Refer to the
combine operator's manual for updates.
NOTE:
For New Holland CR models 6.80, 6.90, 7.90, 8.90, 9.90, and 10.90, refer to
Series—Model Year 2015 and Later), page
1. Select HEADER RAISE RATE on the combine display.
2. Use the + or – buttons to change the setting.
3. Press ENTER to save the new setting.
NOTE:
The raise rate can be changed from 32–236 in steps
of 34. The factory setting is 100.

Setting the Header Lower Rate (New Holland CR/CX Series)

If necessary, the header lower rate (the automatic header height control button or second speed on the header
height rocker switch of the multi-function handle) can be adjusted.
NOTE:
Changes may have been made to the combine controls or display since this document was published. Refer to the
combine operator's manual for updates.
NOTE:
For New Holland CR models 6.80, 6.90, 7.90, 8.90, 9.90, and 10.90, refer to
Series—Model Year 2015 and Later), page
214683
OPERATION
271.
Figure 3.471: New Holland Combine Display
271.
268
3.8.16 New Holland Combines (CR
3.8.16 New Holland Combines (CR
Revision A