Installing Tall Crop Feed Plates Under Driven Deflector; Installing Tall Crop Feed Plates Under Driveline Deflector - MacDon R85 Operator's Manual

Installing Tall Crop Feed Plates under Driven Deflector
1. Lower header fully.
2. Stop the engine and remove the key.
3. Open the cutterbar doors.
Doors, page 33.
4. Remove driven deflector.
Driven Deflector, page
5. Remove the tall crop feed plates from storage. Refer
to
4.11.1 Removing the Tall Crop Feed Plates from
Storage, page 102.
6. Position feed plate (A) on the disc, ensuring that
hole in feed plate registers on disc. Position plate
approximately as shown and align holes.
IMPORTANT:
Depending on disc (B) rotation, the feed plate (A)
should be positioned so that when holes are aligned,
the leading edge of the feed plate is farther from the
accelerator (B) than the trailing edge.
7. Install the deflector.
Deflector, page 150.
8. Close the cutterbar doors.
Doors, page 33.
Installing Tall Crop Feed Plates under Driveline Deflector
DANGER
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and remove
the key from the ignition before leaving the operator's seat for any reason.
214014
OPERATING THE HEADER
Refer to
3.5 Cutterbar
Refer to
Removing the
149.
Refer to
Installing the Driven
Refer to
3.5 Cutterbar
Figure 4.26: Right End Shown
Figure 4.27: Right End Top View
103
Revision B