MacDon FlexDraper FD1 Series Operator's Manual page 241

9. Select HEADER (A) from the list of calibration options.
10. With HEADER selected, press icon (A). The icon will
turn green.
11. Click button (A) and instructions will appear on screen
to guide you through the remaining calibration steps.
NOTE:
If an error code appears during calibration, the sensor is
out of voltage range and will require adjustment. Refer
to Checking Voltage Range from the Combine Cab
(John Deere S and T Series), page
NOTE:
If float was set heavier to complete the AHHC
calibration procedure, adjust to recommended
operating float after the calibration is complete.
214683
OPERATION
212.
217
Figure 3.351: John Deere Combine Display
A
Figure 3.352: John Deere Combine Display
A
Figure 3.353: John Deere Combine Display
A
Revision A