MacDon FlexDraper FD1 Series Operator's Manual page 400

21. Disconnect the hydraulic center-link as follows:
a. Remove the lynch pin and clevis pin (A), and lift the
center-link (B) clear of the bracket.
b. Replace the clevis pin (A) and secure with
lynch pin.
NOTE:
It may be necessary to raise or lower the feeder
house to adjust the length of the center-link and
relieve excess load on the center-link.
NOTE:
•
If on the ground: Push reel fully forward to reduce oil
loss.
•
If on transport: Pull reel fully back.
22. Disconnect electrical connector (A).
NOTE:
If colored plastic ties are missing, replace them before
disconnecting hoses.
23. Disconnect the case drain, knife, and draper drive
hydraulic hoses at the coupler bracket (B). Cap off ends
immediately to avoid loss of oil.
24. Store and secure hoses on float module frame.
25. Disconnect the quick disconnects (if installed)
as follows:
a. Line up the slot (A) in the collar with the pin (B) on
the connector.
b. Push the collar towards the pin, and pull the
connector to disengage.
c. Install plugs or caps on the hose ends (if
equipped).
214683
HEADER ATTACHMENT/DETACHMENT
376
A
B
Figure 4.149: Hydraulic Center-Link
B
Figure 4.150: Header Connections
A
Figure 4.151: Quick Disconnect Coupling
A
B
Revision A