Converting From Ultra Narrow Or Narrow Configuration To Wide Configuration - MacDon FlexDraper FD1 Series Operator's Manual

4.1.6 Converting from Ultra Narrow or Narrow Configuration to Wide
Configuration
One kit of MD #287031 48
head bolts (MD #252703), and two M6 tee nuts (MD #197263) are recommended to close the flighting mounting
locations. These parts can be ordered from a MacDon Dealer.
The Narrow, Ultra Narrow, and Wide auger configurations
are shown at right. When converting from Narrow or
Ultra Narrow configuration to Wide configuration, you will
need to replace the existing flightings (A).
NOTE:
Some parts have been removed from the illustrations for
clarity.
1. If necessary to improve access and ease installation, remove float module from combine. For instructions, refer
to 4 Header Attachment/Detachment, page
48. MD #287031 contains wear-resistant flightings, and is available only through MacDon Parts.
214683
HEADER ATTACHMENT/DETACHMENT
is required to convert to this configuration. Two flighting plugs (MD #213084), two M6 hex
307.
1
A
2
3
Figure 4.25: Auger Configurations (Rear View)
1 - Narrow Configuration
3 - Wide Configuration
320
A
A
A
2 - Ultra Narrow Configuration
Revision A