Changing Oil Filter - MacDon FlexDraper FD1 Series Operator's Manual

5.4.4 Changing Oil Filter

Change the oil filter after the first 50 hours of operation and every 250 hours thereafter.
Obtain filter part (MD #202986) from your MacDon Dealer.
DANGER
To avoid bodily injury or death from unexpected start-up of machine, always stop engine and remove key
from ignition before leaving operator's seat for any reason.
1. Clean around the mating surfaces of the filter (B) and
manifold (A).
2. Place a suitably sized container (approximately 1 liter
[0.26 gallons]) under the oil drain spout (C) to collect oil
runoff.
3. Remove the spin-off filter (B) and clean the exposed
filter port in the manifold (A).
4. Apply a thin film of clean oil to the O-ring provided with
the new filter.
5. Turn the new filter into the manifold (A) until the O-ring
contacts the mating surface. Tighten the filter an
additional 1/2 to 3/4 turn by hand.
IMPORTANT:
Do NOT use a filter wrench to install the new filter.
Overtightening can damage the O-ring and filter.
214683
MAINTENANCE AND SERVICING
Figure 5.30: FM100 Hydraulics (Cover Opened
to Show Manifold)
410
A
B
C
Revision A