MacDon FlexDraper FD1 Series Operator's Manual page 522

4. Remove the tube connectors (B), screws (A), and nuts
from the draper joint to uncouple the draper.
5. Pull the draper off the drive roller.
6. Align the setscrews with the hole (A) in the guard.
Remove the two setscrews holding the motor onto the
drive roller.
NOTE:
The setscrews are 1/4 turn apart.
7. Remove the four bolts (B) securing the motor to the
drive roller arm.
NOTE:
It may be necessary to remove the plastic shield (C) to
gain access to the top bolt.
8. Remove the bolt (A) securing the opposite end of the
drive roller (B) to the support arm.
9. Remove the drive roller (B).
214683
MAINTENANCE AND SERVICING
Figure 5.209: Draper Connector
Figure 5.210: Drive Roller
Figure 5.211: Drive Roller
498
A
C
B
B
B
A
B
A
Revision A